A family roofing company serving Spring Branch and the rest of Texas through our network of local crews. Tin roofs, repairs and replacements done right.
From a single lifted panel to a full tear off, we handle every roofing job a Spring Branch, TX home is likely to need.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
We match the guard to your trees and your gutter profile, and make sure water can still get in where it is supposed to.
Low slope roofs fail at the joints and around anything that sticks through them. That is where we start, not out in the middle of the field.
A replacement is a big spend and it should feel orderly. We schedule around dry weather, work in the right order, and never leave a house open overnight.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
After a storm we walk the roof, photograph everything we find, and write an itemized estimate you can hand straight to your adjuster.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
A shingle repair should not be visible from the street. We match as close as the weathering allows and blend the new work into the old.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
We have never charged for an estimate and we are not about to start. A Spring Branch homeowner ought to be able to find out what a roof costs without buying a sales pitch first, so we measure, photograph what we find, and put a real number on paper.
What people tell us most often is that we told them the truth. Sometimes that truth is that the Spring Branch roof they were ready to replace has another eight or ten years in it and only needs the valleys resealed.
A family roofing company that has kept the same habits since 2002.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Wondering about metal versus shingle, or what a new roof runs in Spring Branch? Start here.
A typical Spring Branch shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Often, yes. Plenty of the Spring Branch roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Sometimes. If the decking is sound and there is only one layer of shingles, a Spring Branch metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
For most Spring Branch homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Most Spring Branch metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
No. Estimates are always free in Spring Branch. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
We would rather let the work, and the people who paid for it, do the talking.
"Second roof they have done for our family. My sister used them first and would not hear of me calling anybody else."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"They reroofed the porch and matched it to the house so well you cannot tell where the old work stops and the new starts."
We take care of homeowners in these neighboring communities as well.